FYI we no longer sell race fuel.
This kit is Primarily used for Original Factory A/C Equipped Vehicles For 1976 and Later Cars and 1980 & later Trucks with H Block Expansion Valve Vehicles With Original Factory A/C Evaporators that came with H Block Expansion Valve. Includes Basic Installation Overview Instructions.
PICTURE SHOWN NOT REPRESENTATIVE OF ALL UNDERHOOD KITS, YOURS MAY VARY ACCORDING TO APPLICATION.
NOTE:1- On Most High Mounted Compressors, For Cleaner installation, we recommend mounting the compressor with both ,suction & discharge ports, pointing towards right side inner fender. Then use a pair of 45 degree fittings (BLA1312-3 & BLA1313-3) at compressor, and route hoses across top of Alternator.
2-Larger #8 Fitting Is always installed on top.
3-Smaller #6 Fitting is always installed at bottom. #6 Outlet fitting goes to Receiver Dryer .
4-Upon Installation, Always add 1/2-3/4 ounce of PAG 100 to Condenser Before Installation.
5-Condenser will be Under Nitrogen Pressure when caps are removed
6-Always fit largest condenser to opening in radiator support for maximum efficency and cooling
7-Some triming may be necessary at corners of Condenser Mounting Flanges for Fit on Some E Bodies and B Bodies.
8-Always mount Condenser as high as possible and as close as possible to radiator support opening.
9-When System is flushed Clean and dry, and you are using a NEW BPE provided Compressor (which already has Oil in it), add 1.5-2 ounces (total) PAG 46 Refrigerant Oil to rest of the system, usually split between new condensor, evaporator, and fresh receiver dryer.
